SOLIDWORKS PCB Rookie Camp Part IV: Wire or Bus Entry

The road through past NFL playoffs brought about an all-new buzzword, Run-Pass Option, or RPO. RPO was a part of the most memorable play, the “Philly Special.”

SOLIDWORKS PCB also gives YOU a winning formula by giving you OPTIONS when entering a bus! A bus carries multiple signals on a single line to help keep your drawings clean and concise. I use two options when adding a signal to a bus, and either entry method will allow you to get your signals where they need to go with added flexibility to move around later as needed!

SEE THE SOLIDWORKS PCB BUS ENTRY IN ACTION